Water Loop Temperature on a Pulp Moulding Line: Why Two Degrees Shows

Published: 2026-11-13 | Author: Dragonegg Editorial

What does the water loop temperature actually control?

It controls the rate at which water leaves the forming head and the consistency of the slurry at the face. Warmer water drains faster and leaves a drier web; colder water leaves a wetter web that sticks to the mould.

The set point is therefore a forming parameter, not a utility setting. Treating it as a utility is how a line ends up with unexplained sticking after a seasonal change.

Where should the temperature be measured?

At the head, not at the tank. The tank may hold its set point while the line to the head loses heat, and the difference grows with distance and with a cold ambient.

Measure at both points during commissioning, then log the head reading each shift. If tank and head diverge by more than a couple of degrees, the insulation or the circulation rate needs attention.

Why does sticking appear at some times of year?

Because ambient temperature changes the loss between tank and head, and because humidity changes how fast the formed web releases. A line commissioned in summer can show release problems in the first cold week without any setting being touched.

Log the ambient alongside the head temperature for a full year. The correlation tells you the compensation range you need, and it takes one column in an existing log.

How does release agent interact with temperature?

Release agent compensates for a web that wants to stick; it does not fix a temperature that is out of band. Adding agent to solve a cold-water problem raises cost and can leave residue that shows on the finished carton.

If sticking appears, check head temperature and vacuum before touching the agent dose. Those two explain most cases, and both are cheaper to correct.

What tolerance should be written into the process sheet?

State the head temperature set point with a band of about plus or minus two degrees, the measurement point, and the frequency. Then state which parameter to check first when release fails, in order: head temperature, vacuum at the face, agent dose.

That order matters more than the band. Without it, operators adjust whichever control is nearest, and the line drifts into a combination that no one can reproduce.

What does a cold-start morning tell you about the loop?

A line that needs twenty minutes to reach stable release after a cold start is telling you the loop has more thermal mass than the set point assumes. Record the time from start to first good carton, not the time to reach temperature.

If that start-up time grows across the season, the cause is usually insulation or circulation rather than the heater. Both are cheap to check and expensive to ignore, because the loss appears as scrap at the start of every shift.

See also Vacuum System Drift · Mould Cleaning Interval · Egg Carton Moisture: Oven-Dry Method · Furnish Blend and Forming Yield · Mould Cavity Count Selection · Denesting Force on a Packing Line.

AI Assistance Disclosure. This article was prepared with AI assistance for drafting and structuring, and reviewed by the content team before publication. Performance, tooling and pricing depend on the item, fibre and volume; the specifications described here are general and are confirmed per quotation.