Cleaning Interval for Pulp Carton Moulds: Condition, Not Calendar

Published: 2026-11-13 | Author: Dragonegg Editorial

Why a fixed calendar interval is the wrong basis?

Because the rate of build-up depends on furnish, water hardness and how long the line runs between stops. Two plants with the same mould and the same carton can need intervals a factor of two apart.

A calendar interval that is safe for the dirtiest case wastes cleaning stops on the cleanest one, and stops cost more than cleaning.

What are the three signals that set the interval?

First, surface feel: a mould face that has lost its slip develops a drag when wiped. Second, carton weight: build-up in deep cavities reduces the volume deposited and shows as a slow drift. Third, release quality: the first sign is usually a small increase in sticking at the deepest cavity, not across the whole mould.

Track all three for a month, then set the interval at about 80 percent of the shortest observed time to the first signal.

What does cleaning actually remove?

Fines that compact into the screen, calcium from hard water, and release residue. Each needs a different approach: fines respond to back-flushing, calcium to a mild acid wash, residue to a detergent.

Using one method for all three is why some moulds are cleaned often and still perform poorly. Identify which of the three is present before choosing the procedure.

How should cleaning be verified?

By a form test, not by looking. Run five cartons immediately after cleaning and weigh them; compare against the weight taken just before cleaning. If the difference is under one percent, cleaning was not needed at that point.

Keep those two weights on the cleaning record. The pair is what makes the interval defensible, and it takes less time than the written sign-off alone.

When should the interval be shortened permanently?

When the same signal returns within 70 percent of the current interval on three consecutive cycles, or when a change of furnish or water source has been made. Both are reasons to re-baseline rather than to clean more often by feel.

Write the new interval and the reason into the process sheet, with the date. An interval without its reason gets changed back by the next shift supervisor.

Should cleaning be done hot or on a cooled mould?

Cooled, and dried before restart. Cleaning a hot mould drives the cleaning solution into the screen, where it stays and contaminates the first cartons of the next run.

Allow the mould to reach a temperature where a gloved hand can hold it, clean, rinse, then dry with air before the first form. The first ten cartons after a restart should be scrapped and weighed as the verification sample.

Record the restart sample with the cleaning record, so the next interval decision has a before-and-after pair rather than a memory of how it looked.

See also Vacuum System Drift · Water Loop Temperature · Mould Cavity Count Selection · Mould Cavity Balancing Guide · Furnish Blend and Forming Yield · Ink Adhesion on Pulp Surface.

AI Assistance Disclosure. This article was prepared with AI assistance for drafting and structuring, and reviewed by the content team before publication. Performance, tooling and pricing depend on the item, fibre and volume; the specifications described here are general and are confirmed per quotation.