Cup Depth in Egg Cartons
Why Cup depth Gets Copied Wrong
Settings travel between jobs; the furnish, the the mould and the the drying profile do not.
A cup that is too deep costs material on every carton.
A copied setting is a hypothesis, not a recipe.
The Cup depth Symptom Map
Every cup depth problem announces itself somewhere: in the finished carton, in scrap, in cycle time.
On cup depth the same symptom traces to one of three places: the mould, the furnish, or the drying profile. Checking in that order costs less than checking in parallel.
Map the symptom to the station before touching the machine.
Two Levers for Cup depth
the mould and the drying profile move together. One alone gives you a part that meets the target and cannot be repeated.
Record the setting before the change and the result after a full run. A change without a baseline cannot be reversed with confidence.
Record both numbers at the moment the part was good.
What Cup depth Costs When Ignored
The visible cost is broken eggs and rejected pallets. The hidden cost is a retailer chargeback that arrives a month later.
The hidden cost arrives late, which is why it never enters the technical argument.
Closing Out a Cup depth Issue
Close it with a measurement, a date and a name. Anything less reopens next quarter.
That is the difference between solving and documenting a solution.
Where to Start With Egg carton cup depth fit
Start with the measurement, not with the setting. Take five parts from the current run, measure the same point on each, and write the numbers down before changing anything. That record is the only baseline you will have, and without it every later adjustment is a guess dressed as a decision.
Then change one input and wait for a full cycle plus the transport delay before looking again. Corrections stacked inside that delay overshoot every time, and the resulting part usually sits further from target than the one you started with.
Finally, ask whether the variation you are chasing is inside the tolerance the customer actually specified. Lines that are tuned past that point consume attention that would be better spent on the next defect down the list.
Questions Buyers Ask
What is a normal range for cup depth?
The practical band depends on the part, but the rule is the same: hold it through a full shift including the first hour after changeover.
How do I tell a cup depth problem from a furnish problem?
Check the tool or board first, then the material, then the process. A defect on every unit is process; on one position it is tooling.
How much does it cost to fix cup depth?
Most fixes are process or tooling time rather than capital. That order matters.
When should I stop tuning cup depth?
Stop when the measurement holds for a full run and the next change would cost more than the variation it removes.
What is the most common mistake with egg carton cup depth fit?
Assuming the setting that worked on the previous job will work here. The tool, the furnish and the drying profile move together, so a setting copied across a change usually lands outside the band.
How do I verify the fix held?
Measure the same point on five consecutive parts, then repeat after a full shift without touching anything. A fix that holds for five parts and not for five hours was a coincidence.
Next Step
Send the drawing, the target and the current settings, and the list can be narrowed to two or three likely causes before any hardware change is discussed.
See also see the related detail.
See also see the related detail.
See also see the related detail.
See also see the related detail.
See also read the full note.